GST Addressable Module
DI-9301E Digital Single Input and Output Module
Features
The dry contact input port can be programmed to NC or NO and monitored.
The input can also be programmed as “self-answering”, which means that the Input port monitoring is disabled, and the module will directly send a “status” signal to FACP when the dry-contact output changes state.
Addressable unit. Address can be programmed in field.
Input port utilizes AD sampling technology for precise testing.
DIN-Rail mounted or Wall mounted.
Standard: EN 54-18:2005
Description
With a microprocessor, the DI-9301E Digital Single Input and Output Module (the module) can communicate with fire alarm control panel (FACP), check loop power-cut, control output, circuit faults, logic state of input signals, and state LEDs. On receiving start command from the FACP, it will close the output relay and illuminate the active indicator.
Connection and Cabling
(Z1, Z2) IN & OUT: Connect with the loop of FACP, polarity-insensitive.
I, G: Connect with normally open dry contact of an input device that closes when the device is in alarm or changes state. It may also be set to normally closed input by hand held programmer.
COM, NO, NC: Dry contact output terminals (Note: there is 30kΩ resistance between NO and COM).
CODE: Connect with the programmer.
Recommended Wiring: 1.0mm2 or above fire cable for all terminals. Subject to local codes.